1. Product introduction of autoclaved aerated concrete equipment:
The selection and quantity of autoclaved aerated concrete equipment are determined according to the process design plan. Commonly used autoclaved aerated concrete equipment includes concrete cutting machine, pouring machine, autoclave, steam curing car, crusher, ball mill, conveyor, mixer. , mold frame, spreader, boiler, etc.; pouring is divided into fixed and mobile pouring, the cutting method is currently dominated by flip cutting, other batching systems, autoclave curing and other equipment are similar.
A new type of building material aerated concrete can be made by using autoclaved aerated concrete equipment, which mainly includes two types of blocks and plates. Different formulas and processes can be used to make load-bearing wall blocks, non-load-bearing wall blocks and thermal insulation blocks. The board is divided into roof insulation board, insulation floor board and insulation wall board.
2. Introduction to the production process of autoclaved aerated concrete
Aerated concrete can be produced by steam curing with an annual output of 20,000 to 300,000 m3 of aerated concrete according to the type of raw materials, quality, and technological characteristics of equipment, etc., using different processes. In general, fly ash or silica sand and slag are ground into slurry with water, powdered lime, appropriate amount of cement, gypsum, foaming agent and foam stabilizer are injected into the mold frame after stirring, and after static foaming and solidification, it is cut into Blocks or plates of various specifications are sent into the autoclave by the steam curing vehicle, and are cured by high temperature and high pressure steam to form porous and lightweight concrete products.
3. Process flow of autoclaved aerated concrete equipment:
Autoclaved aerated concrete equipment can be produced by different processes according to the type of raw materials, quality, process characteristics of the main equipment, etc. But in general, fly ash or silica sand is ground into slurry with water, powdered lime, an appropriate amount of cement, gypsum and foaming agent are added, and after stirring, they are injected into the mold frame, and after static oxygen foaming and curing, they are cut into various Specification blocks or plates are sent into the autoclave by the steam curing vehicle, and the porous and lightweight aerated concrete products are formed under the curing of high temperature saturated steam.
