Aerated block equipment appears in the process of production, which is a problem that many newly put into production of gas -added block equipment often encountered. Adhesion refers to the adhesion between the kettle and the gas block, which is not easy to divide into part of the waste and sub -products. The main reasons for the production of the gas block equipment are the following four points:
First, the blank body is too soft when cutting. After the wire is cut, some of the blank body in the cut latter is squeezed into thick mud by the steel wire, so that the body on both sides of the cutting seam is re -connected.
Second, when steaming, due to the negative pressure of vacuum and steaming pressure, this connection firmly becomes firm.
Third, when cutting and cutting, the weight of each layer of the blank can make it easier and firmly sticky.
Fourth, due to the changes in raw materials, the production production has not been adjusted, so that the body is cut and adhesive.
The core equipment of the gas block equipment is not as the cutting machine. The cutting machine is used to cut the blanking of the air -stop equipment that has been stopped and hardened, and the size of the air is used as long as the size of the use requirements. The fascinating block equipment cutting machine is divided into two types: empty flip cutting machine and ground flip cutter. They have different production processes, different equipment configurations, but the cutting process is the same. The full -automatic cutting machine adopted by the gas block equipment not only has high production efficiency and high product qualification rate, but also accurate cutting size. The adhesion of the gas block is also greatly reduced.
The cutting machine structure of the gas block equipment is streamlined and practical, and the installation and maintenance are convenient. The design of the design of the designed body is 600mm, the height is 1200mm, the cutting wire is short, it is not easy to break, it is not easy to drift, and the cutting accuracy is high. The vertical cutting device is fixed, and the cutting car is taken to complete the vertical cutting, and the cutting time is short. The horizontal cutting device is cut at the horizontal steel wire to shorten the length of the cutting steel wire to ensure the cutting accuracy. After the body is erected, the milling can be completed during vertical cutting. The cutting machine of the gas block equipment uses six -sided cutting. The quality of the product is not affected by the deformation of mold oil and mold, and the cutting accuracy is high.
